Technicolor - Thomson ST585 V6 - Manual (Page 588)

E-DOC-CTC-20061027-0004 v1.0
NAT Commands
564
nat ifconfig
Modify address translation on an IP interface.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
nat ifconfig intf =
translation = <{disabled | enabled | trans-
parent}>
intf The IP interface name. REQUIRED
translation Enable or disable address translation.
Choose between:
> disabled : Address translation is disabled.
>
enabled : Address translation is enabled.
>
transparent : An inside address is translated into the same
outside IP address. In fact, no translation happens and the
IP packets passing through the Thomson ST remain
untouched.
The default is disabled .
REQUIRED
=>nat iflist
Interface
NAT
loop disabled
myPPP_ppp disabled
eth0 transparent
=>nat ifconfig intf=myPPP_ppp translation=enabled
=>nat iflist
Interface
NAT
loop disabled
myPPP_ppp enabled
eth0 transparent
=>
nat iflist Display the address translation configuration on all the interfaces.