Technicolor - Thomson ST585 V6 - Manual (Page 659)

E-DOC-CTC-20061027-0004 v1.0
Service Commands
635
service system ipadd
Add an IP address (range) to the access list.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
service system ipadd name =
ip =
name The name of the system service for this access list. REQUIRED
ip The IP address (range) for this access list. REQUIRED
=>service system list name=SIPPBX expand=enabled
Idx Name
Protocol SrcPort DstPort Group State
---------------------------------------------------------------------------------
1 SIPPBX udp 5060 disabled
Description................ SIP PBX, registrar and proxy
Properties................. server
Managed parameters......... state port acl map log
Source Ip Selection........ auto
Interface Access List...... any
Ip Access List............. any
NAT Port List.............. 5060
=>service system ipadd name=SIPPBX ip=192.168.1.64
=>service system list name=SIPPBX expand=enabled
Idx Name
Protocol SrcPort DstPort Group State
---------------------------------------------------------------------------------
1 SIPPBX udp 5060 disabled
Description................ SIP PBX, registrar and proxy
Properties................. server
Managed parameters......... state port acl map log
Source Ip Selection........ auto
Interface Access List...... any
Ip Access List............. 192.168.1.64
NAT Port List.............. 5060
=>
service system ipdelete Delete an IP address (range) from the access list.