Technicolor - Thomson ST585 V6 - Manual (Page 334)

E-DOC-CTC-20061027-0004 v1.0
Eth Commands
310
eth switch mirror ingress
Enable or disable the specified port to be the Mirror Ingress Port.
SYNTAX:
where:
EXAMPLE:
Here port 2 is enabled as Mirror Ingress Port
Here port 2 is disabled as Mirror Ingress Port
RELATED COMMANDS:
i Only one port can be the Mirror Ingress Port at any one time.
But a port can be the Mirror Egress Port and the
Mirror Ingress Port at the same time.
eth switch mirror ingress port =
[state = <{enabled | disabled}>]
port The port to be the Mirror Ingress Port.
Note If no port number is specified, then the port number of
the current Mirror Ingress Port is shown.
REQUIRED
state Enable or disable the port as Mirror Ingress Port.
The default is
enabled .
OPTIONAL
=>eth switch mirror ingress port=2
=>eth switch mirror ingress
Ingress mirror port = 2
=>
=>eth switch mirror ingress
Ingress mirror port = 2
=>eth switch mirror ingress port=2 state=disabled
=>eth switch mirror ingress
=>
eth switch mirror capture Define the specified port to be the Mirror Capture Port.
eth switch mirror egress Enable or disable the specified port to be the Mirror Egress Port.