Technicolor - Thomson ST585 V6 - Manual (Page 299)

E-DOC-CTC-20061027-0004 v1.0
Eth Commands
275
eth bridge ifconfig
Modify a bridge interface configuration.
SYNTAX:
where:
eth bridge ifconfig [brname = <{bridge}>]
intf =
[dest = ]
[portstate = <{disabled | learning |
forwarding}>]
[retry = ]
[prioconfig = <{disabled|over-
write|increase}>]
[vlan = ]
[ipprec = <{disabled|precedence|dscp}>]
[priority = ]
[regenprio = ]
[ingressfiltering = <{disabled |
enabled}>]
[acceptvlanonly = <{disabled | enabled}>]
[mcastfilter = <{disabled|enabled}>]
[dynvlan = <{disabled|enabled}>]
[igmpsnooping = <{disabled|enabled}>]
brname The name of a bridge instance. OPTIONAL
intf The name of the bridge interface to be configured. REQUIRED
dest The destination for this interface.
Typically an ATM or a physical interface name. OPTIONAL
portstate The bridge portstate for this interface.
Choose between:
> disabled
> learning
> forwarding.
The default is forwarding .
OPTIONAL
retry A number between 0 and 65535.
Represents the number of times the Thomson ST retries to set
up a WAN connection before giving up.
The default is
10 .
OPTIONAL
vlan Select the default VLAN. OPTIONAL
prioconfig The priority configuration for this interface. OPTIONAL