Technicolor - Thomson ST585 V6 - Manual (Page 403)

E-DOC-CTC-20061027-0004 v1.0
GRP Commands
379
grp rip ifconfig
Configure a RIP interface.
SYNTAX:
where:
grp rip ifconfig intf =
[rip = <{disabled | enabled}>]
[rxversion = <{rip_unspec | rip_v1 | rip_v2 | rip_v1-2}>]
[authmode = <{none | cleartext}>]
[authstring = ]
[splithorizon = <{disable | enable}>]
intf The name of the RIP interface to be configured.
Tip Use the command :grp iflist to obtain a list of avail-
able interfaces.
REQUIRED
rip Enabled or disabled RIP on this interface.
The default is
disabled .
OPTIONAL
rxversion Configure the RIP receive version to be applied.
Choose between:
> rip_unspec : No RIP version is specified as such. The actual RIP
version to be used is negotiated with the remote side.
>
rip_v1 : RIP version 1 is used.
>
rip_v2 : RIP version 2 is used.
> rip_v1-2 : RIP version 1 and RIP version 2 are used.
The default is rip_unspec .
OPTIONAL
authmode Configure the RIP authentication mode.
Enter the mode in cleartext or specify none in case no authentication
mode is required.
The default is
none .
OPTIONAL
authstring Configure the authentication string for the RIP authentication
password.
Note Leave authstring unspecified in case authmode is none .
OPTIONAL
splithorizon Enable or disable the split horizon status for this interface.
The default is
enabled .
OPTIONAL