Technicolor - Thomson ST585 V6 - Manual (Page 610)

E-DOC-CTC-20061027-0004 v1.0
PPP Commands
586
password The password for remote PAP/CHAP authentication. OPTIONAL
acname The Access Concentrator name for a PPPoE session.
Tip Use the command :ppp ifscan to obtain the names of
available access concentrators, if any.
OPTIONAL
servicename The Service Name for a PPPoE session.
Tip Use the command :ppp ifscan to obtain the available
service names, if any.
OPTIONAL
pcomp Try (enabled) or do not try (disabled) to negotiate PPP protocol
compression (LCP PCOMP).
The default is
disabled .
OPTIONAL
accomp Try (enabled), do never try (disabled) or negotiate (negotiate) to
negotiate PPP address & control field compression (LCP ACCOMP).
In most cases, LCP ACCOMP should not be disabled nor negotiated,
in other words, the address field FF-03 should not be sent over ATM.
The default is
enabled .
Note If the accomp parameter is set to “negotiate”, the local side
of the PPP connection demands to do ACCOMP and adapts
itself to the result of this negotiation.
OPTIONAL
trace Enable or disable verbose console logging.
The default is
disabled .
OPTIONAL
concentrator The access concentrator is on this side of the PPPoE connection.
Choose between:
>
enabled : the PPP connection is terminated on the Access
Concentrator (here the Thomson ST itself)
> disabled : the Thomson ST is PPP client.
The default is disabled .
OPTIONAL
auth Select the authentication protocol.
Choose between:
>
pap : Password Authentication Protocol (PAP) authentication will
be forced.
> chap : Challenge Handshake Authentication Protocol (CHAP)
authentication will be forced.
> auto : CHAP authentication will be used. If CHAP authentication is
not successful, PAP authentication will be used instead.
The default is auto .
OPTIONAL
restart Automatically restart the connection when Link Control
Protocol (LCP) link goes down (enabled) or not (disabled).
The default is
disabled .
OPTIONAL
retryinterval A number between 0 and 65535 (seconds).
Represents the intermediate interval between two retries to establish
the connection on ATM level.
The default is
10 .
OPTIONAL
passive Put the link in listening state in case LCP times out (enabled) or not
(disabled).
This parameter allows to determine whether the link should be left
open to wait for incoming messages from the remote side after 10
unsuccessful tries to establish the connection or not.
The default is
disabled .
OPTIONAL