Nat maplist, Nat commands, Syntax – Technicolor - Thomson ST585 V6 User Manual
Page 595: Example: related commands
E-DOC-CTC-20061027-0004 v1.0
NAT Commands
571
nat maplist
Display the address mapping for a NAT enabled interface.
SYNTAX:
where:
EXAMPLE:
RELATED COMMANDS:
nat maplist
[intf =
[expand = <{disabled | enabled}>]
intf
The IP interface name.
Note
If not specified, the address mapping for all the NAT
enabled interfaces will be shown.
OPTIONAL
expand
Enable or disable expanded listing.
The default is
disabled
.
OPTIONAL
=>nat maplist
Idx Type Interface
Outside Address
Inside Address
Use
1 NAPT myPPP_ppp
100.100.100.1
unmapped
0
1 NAPT eth0
any:80
127.0.0.1:8080
0
2 NAPT eth0
any:1080
127.0.0.1:8080
0
3 NAPT eth0
any:8080
127.0.0.1:8080
0
=>maplist intf=myPPP_ppp expand=enabled
Idx Type Interface
Outside Address
Inside Address
Use
1 NAPT myPPP_ppp
100.100.100.1
unmapped
0
Access List................... 10.0.0.0/24
Foreign Address............... any
Protocol...................... any
Flags......................... Static
Description................... Outbound NAPT without defserver
=>
Add an address mapping to a Network Address Translation (NAT) enabled
interface.