Technicolor - Thomson ST585 V6 - Manual (Page 667)

E-DOC-CTC-20061027-0004 v1.0
SNMP Commands
643
34 SNMP Commands
Introduction
This chapter describes the commands of the snmp command group.
Contents
This chapter covers the following commands:
snmp config Show/set global Simple Network Management
Protocol (SNMP) parameters. 644
snmp get Get from the supplied SNMP Object IDentifier (OID). 645
snmp getnext GetNext from the supplied SNMP OID. 646
snmp walk Walk from the supplied SNMP OID. 647
snmp community add Configure an SNMP community string to allow SNMP access
over IP. 648
snmp community delete Delete an SNMP community string to prevent SNMP access
over IP. 649
snmp community list List all SNMP community strings in use for SNMP access over
IP. 650
snmp community modify Modify an SNMP community string to allow SNMP access over
IP. 651
snmp ifadd Create a new SNMP interface. 652
snmp ifdelete Delete an SNMP interface. 653
snmp ifattach Attach an SNMP interface. 654
snmp ifdetach Detach an SNMP interface. 655
snmp ifconfig Modify an SNMP interface. 656
snmp iflist Display the SNMP interfaces. 657