IAI America IA-101-X-USBMW - Manual (Page 94)

4. Program Edit W
indow
86
This is not displayed
for SSEL, ASEL and
PSEL
(3) Writing to the flash ROM
Once the program has been transferred to the controller, the following confirmation dialog box with the
message, "Write Flash ROM?" will be displayed.
Fig. 4.12 Confirmation Fig. 4.13 Confirmation
(X-SEL-J/K, P/Q, TT, SSEL, ASEL, PSEL) (X-SEL-JX/KX, PX/QX)
In case of SSEL, ASEL, PSEL, X-SEL-P/Q and PX/QX compatible with increased memory (with gateway
function), or R/S, RX/SX, and RXD/SXD controllers, the following screens will be displayed. (PC interface
software version 7.2.0.0 or later)
Fig. 4.14 Confirmation Fig. 4.15 Confirmation
(X-SEL-P/Q, R/S, SSEL, ASEL, PSEL) (X-SEL-PX/QX, RX/SX, RXD/SXD)
Click and select a desired item (Program, etc.) to write to the flash ROM.
Click Yes (Y)ĺ The memory data will be written to the flash ROM.
Click No (N) ĺ The memory data will not be written to the flash ROM. If No (N) is selected, the controller
will clear all data in its memory after a reset (i.e., after the controller power is reconnected
or a software reset is executed), and then load the data from the flash ROM. (The
controller will operate in accordance with the transferred data until a reset is executed.)
* The number of writing to the flash ROM is limited. (can write approx. 100,000 times)
If you don’t want to write all the data to the flash ROM, select "Write selected data region."