IAI America IA-101-X-USBMW - Manual (Page 76)

3. Menu W
indow
68
[When the RC-axis position data in RC controller is used]
RC-axis position data in RC controller can not be saved in the PC interface software for X-SEL.
Fig. 3.18 Warning
(When RC-axis position data is being saved)
€ PC Interface Software of a Version Earlier than V7.2.0.0
ƒ Transfer to Controller (L) Transfer saved program and position data to the controller.
(Note) Files collected by the SSEL, ASEL, and PSEL controllers in the program mode cannot be
transferred to the controller in the positioner mode. In the same way, files collected in the positioner
mode cannot be transferred to the controller in the program mode. If any different file is transferred,
the following message will be displayed:
Fig. 3.19 Message
€ PC Interface Software of a Version V7.2.0.0 or later
Õ Online connection with the controller
Transfer to Controller/Divide File (L) Transfer to controller or dividing the file can be chosen in the
Transfer/Divide Selection Screen.
Õ Offline
• Divide File (L)
The file containing the entire data can be divided on the Data
Transfer/Division Selection Screen.
Fig.3.20 Transfer/Divide Selection Screen Fig.3.21 Transfer/Divide Selection Screen
(X-SEL-J/K, P/Q, TT, SSEL, ASEL, PSEL) (X-SEL-JX/KX, PX/QX)