Hitachi GR2000 Series - Manual (Page 90)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview
4-12 GR2K-GA-0015
Ver. 07-02
4.8 Setup of Dial-Up Networking with Remote Operation
Terminal
You can use the remote operation terminal through the dial-up networking with the
own router.
(1) Set up the Own Router
(a) Prepare the modem for the own router:
Procure an applicable modem and set it up to automatically answer calls in
accordance with the modem setup specifications in GR2000 Applications Guide”.
Then, connect the modem to the AUX port of this router.
(b) Set up the configuration information on the own router.
Set up the own router’s IP address and the remote operation terminal’s IP
address on the AUX interface. If the own router’s IP address is 200.10.10.1 and
the remote operation terminal’s IP address is 200.10.10.2, the
setup command
input will be as follows:
Figure 4-8 Example of configuration information setup for AUX
(2) Set up the Remote Operation Terminal
(a) Prepare the modem for the remote operation terminal.
Procure an applicable modem and set it up in accordance with its manual. Then,
connect the modem to the remote operation terminal.
(b) Install and set up the dial-up networking software.
Install the dial-up networking software on the remote operation terminal. Then,
set up the software in accordance with Table 4-6.
(c) The user name and password for authentication by the remote operation
terminal in the dial-up networking sequence are the own router’s login user
name and password. If a user name with its password deleted by the
password
command is entered, authentication will be successful ignoring any password
entry.
Table 4-6 Setup of dial-up networking software on remote operation terminal
No. Setup Item Contents of Setting
1 Server type PPP
2 Network protocol TCP/IP
3 IP address As specified by server
4 Name server address Blank
5 Authentication method No encryption on PAP or password
6 Telephone number Telephone number used by modem on own router
(config)# line aux
(config)# ip aux 200.10.10.1/24 -destination_ip_address 200.10.10.2