6 confirming the state of vc in eompls (l2-vpn) – Hitachi GR2000 Series User Manual
Page 147

Confirmation of interface state and routing state
GR2K-GA-0015
5-47
Ver. 07-02
Figure 5-85 Display of label and forwarding information by IP address designation
Figure 5-86 Display of label and forwarding information by VPN ID designation
5.8.6
Confirming the state of VC in EoMPLS (L2-VPN)
Execute a show mpls 12transport command from the operation terminal to the
router and confirm the state of VC (e.g. VC ID is set as 5).
Figure 5-87 Result of execution of show mpls 12transport command
Check the possible cause according to Subsection 7.11.5, “VC of EoMPLS(L2-VPN)
has not been established”. when the state of VC is not established.
> show mpls forwarding-table 192.168.113.101/32
total:1
FEC NextHop Label Interface Packets
192.168.113.101/32 172.16.113.117 Out 1048575 Department1 4294967295
>
> show mpls forwarding-table vpn Osaka1213
total:2
FEC NextHop Label Interface Packets
VPN:Osaka1213
192.168.11.0/24 172.16.11.5 Out 1048571 Department2 15
/1003223
192.168.12.0/24 - In 30 ********** -
>
>show mpls l2transport vc 5
Transport Interface Name VC Local Remote Tunnel
VC ID State VC Label VC Label Label
5 office1 UP 23 26 1048576
>
Confirm here.