Hitachi GR2000 Series - Manual (Page 111)

Confirmation of interface state and routing state
GR2K-GA-0015 5-11
Ver. 07-02
local IPv4 address of the interface, used for load balance, for of
the ping command.
5.2.9 Confirming the multihome connection
5.2.9.1 Confirmation after setting of configuration definition
(a) Confirmation of route information
Execute a show ip interface command and confirm whether the IPv4 address
defined as multihome connection using a configuration definition command
(ip-address) is properly reflected onto the relevant interface.
Figure 5-23 IPv4 address display during multihome connection
(b) Confirm communication with the relevant destination address.
Confirm using a ping command whether the router can communicate with the
router used as the communication peer of multi-home connection. Also confirm
using a ping command whether the routers that are multihome-connected with
the router and using the same interface can communicate with each other.
Figure 5-24 Flow of ping that confirms multihome connection
> show ip interface
tokyo1: flags=80e3
mtu 1500
inet 172.16.10.1/24 broadcast 172.16.10.255
inet 172.16.20.1/24 broadcast 172.16.20.255
inet 172.16.30.1/24 broadcast 172.16.30.255
NIF0/Line0: UP media 100BASE-TX full(auto) 00:00:87:d0:97:d8
Time-since-last-status-change: 00:00:30
Last down at: 08/21 16:21:01
>