Hitachi GR2000 Series - Manual (Page 202)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview
7-36 GR2K-GA-0015
Ver. 07-02
Figure 7-12 Configuration Example
In the configuration above, the IP address is not lent because the relay agent address
does not coincide with the IP address to which a DHCP/BOOTP client is connected
when data is output as described below during entry of a dhcp show giaddr
command.
> show dhcp giaddr interface Department1
DHCP GIADDR < Department1> : 170.2.2.1
>
Change the applied relay agent address in the procedure below using a DHCP/
BOOTP relay agent function when the relay agent address does not coincide with the
IP address. The operation of a DHCP/BOOTP client connection segment is
temporarily stopped to re-specify the IP configuration definition information of a
DHCP/BOOTP client connection interface.
[IP Configuration Definition Resetting Method]
1. Delete the IP address connected to the client from the IP definitions of the
interface (if all of the IP addresses in the IP definition are deleted, delete
"relay_interface" first).
(config)# show
line Department1 ethernet 0/0 ;
ip Department1{
170.1.1.1/24 ;
170.2.2.1/24 ;
170.3.3.1/24 ;
};
relay {
relay_list 1 170.10.10.10 ;
relay_group Bluegroup {
relay_list 2;
};
relay_interface Department1 relay_group Bluegroup ;
};
(config)# delete ip-address Department 170.1.1.1/24
Are you sure? (y/n): y
(config)# show ip Department1
ip Department1 {
170.2.2.1/24 ;
170.3.3.1/24 ;
};
(config)#