Hitachi GR2000 Series - Manual (Page 282)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview
8-20 GR2K-GA-0015
Ver. 07-02
Figure 8-21 Result of show router Command
For ROUTE-OS7, restart an MPLS program in standby BCU using a restart mpls
command after confirming that standby BCU has been put into the active state
(normal duplex operational state). See Application Guide for details. [ROUTE-OS7]
(a) When setting the priority MC card slot upon activation of the standby
system
If MC cards are installed in both MC card slots 0 and 1, MC card slot 0 is
set to be activated with priority when in the initial state after BCU
replacement. Therefore, if you are operating with the setting that activates
MC card slot 1 with priority using the
set mode command prior to standby
BCU replacement and it is desired to continue activating MC slot 1 with
priority as before after the replacement of the standby BCU, re-execute the
setting by the set mode command indicated below after switching to the
router manager mode from the operating terminal connected to the working
system.
#set standby slot1 reload [CR]
After setting the priority MC card slot at the time of standby system
activation, reactivate the standby system by the
reload command indicated
below from the operating terminal connected to the working system. This
command need not be executed by the router manager.
> reload dump-image -f standby [CR]
After reactivation of the standby system, confirm that the EMA SUPPRESS
LEDs of the RM-I/O ports of both systems have extinguished and that the
operating state of the standby system has switched to “standby.” To confirm
standby system operation status, enter the
show router command shown
below from the operation terminal connected to the operation system. Refer
to the Figure 8-21 of the result of
show router command
> show router [CR]
The above is the procedure for replacing the working/standby system BCU
with the power supply off.
> show router
router: GR2000 S-9181-11 01-01 [ROUTE-OS] , standard model
node : name=System Name
contact=Contact Address
locate=Location
node info: duplex mode
: : : : : :
rm0 : active
rm : HN-F9533-5M3 [BCU-266] 0000
boot : 10/10 20:10:34 , power on , 0 times restart
: : : : : :
rm1 : standby
rm : HN-F9533-5M3 [BCU-266] 0000
boot : 10/19 12:10:34 , power on , 0 times restart
: : : : : :
The operation status of the standby system
must be standby.