Hitachi GR2000 Series - Manual (Page 68)

Hitachi Gigabit Router GR2000 Series Enhanced Version Operations - Device Management Overview
3-6 GR2K-GA-0015
Ver. 07-02
Press the [Ctrl] and [V] keys simultaneously and then enter "?" when using character
"?" in a command parameter.
3.2.7 Input error position indication function
If a command or a parameter has been entered incorrectly, the error position may be
indicated by “-”, and the error message is displayed (refer to the GR2000 Operations
Commands, Vol. 1, Section 1.2, “Messages Displayed by Input Error Position
Indication” on page 1-36.” The same applies when the [TAB] key and the “?” key are
entered.
Referring to the indication location of “-” and the explanation on the error message,
correct the command or the parameter and enter it again. Examples of the input
error position indication are shown in Figure 3-9 through Figure 3-11.
Figure 3-9 Examples of Display When Spelling is Mistaken
Figure 3-10 Examples of Display When the Same Parameter Has Been Entered Twice
Figure 3-11 Examples of Display During Parameter Insertion
3.2.8 Execution of Command Abbreviation
If a command or a parameter abbreviation has been entered and the letters can be
identified as unique commands or parameters, the command is executed. Figure
3-12 shows the examples of execution of command with abbreviated entry.
(config)# line line0 ehternet 1/0
line line0 ehternet 1/0
^
% illegal parameter at ’^’ marker
(config)#
(config)# line line0 ethernet 0/0 -type 10m_full_duplex -type
auto_negotiation
line line0 ethernet 0/0 -type 10m_full_duplex -type auto_negotiation
^
% illegal combination or already appeared at ’^’ marker
(config)#
(config)# line line0 ethernet 0/0 -type
line line0 ethernet 0/0 -type
^
% Incomplete commnad at ’^’ marker
(config)#