Canon imagePROGRAF GP-4000 - Manual (Page 97)

Loading the Lower Roll on the Roll Unit (Option)
Follow these steps to load roll paper in the roll unit (Roll 2 (Lower)).
When selecting Enable in Roll paper auto feed , the roll paper is fed automatically by simply loading it.
Important
• Always load rolls when the printer is on. If the printer is off when you load a roll, the paper may not be •
advanced correctly when you turn the printer on.
• Before loading a roll, confirm whether the inside of the top cover or the output guide is soiled. If these •
areas are dirty, we recommend cleaning them in advance. (See " Cleaning Inside the Top Cover .").
• If using the roll unit as the feed device, depending on the basket position, the ejected roll paper's cut •
end enters the roll unit and may cause a paper jam or affect the print quality when set to "Borderless
Printing" or "Trim Edge First" when loading the paper. In this case, change the basket position, and
then print. (See "
Example Basket Configurations .")
• If Paper retention settings is set to Release , the roll paper is not fed automatically. •
• For details on the paper that can feed roll paper automatically, see "Paper Information List." •
Note
• When roll paper cannot be fed automatically, see " Roll Paper Is not Switched Automatically ." •
1. Tap paper settings display area on Home screen of touch screen. 1.
Note
• If the Home screen does not appear, tap the HOME button. •
• When selecting Enable in Roll paper auto feed. •
Go to step 2.
• When selecting Disable in Roll paper auto feed. •
1. Tap area. 1.
2. Tap Load paper or Replace paper , check message that appears, and then tap Yes . 2.
97