Enlarge and print – Canon imagePROGRAF GP-4000 User Manual
Page 548
6.
Complete the setup
6.
Click
OK
.
When printing is executed, a drapery or banner can be printed according to the roll.
Enlarge and print
1.
Register user-defined paper
1.
Register both the actual desired print size (user-defined paper 1) and original document size created
in application (user-defined document size 2) in the
Page Setup
tab.
Note
• Please set user-defined paper 2 to the same aspect ratio as user-defined paper 1. If the aspect
ratio differs, the enlarged image may not turn out to be the expected size.
After creating user-defined paper 1, if user-defined paper 2 is created after checking
Fix the
Ratio of the Width to Height
, settings can be set to the same aspect ratio.
Also set user-defined paper 2 to a size that doesn't exceed the maximum size supported by the
application.
For example, when printing on paper 600mm wide and 3,000mm long, use the following
settings.
(when setting length to 1/6 the user-defined paper)
User-defined paper 1:
Width
600mm,
Height
3,000mm
User-defined paper 2:
Width
100mm,
Height
500mm
2.
Create original document in application software
2.
Use the registered user-defined paper 2 size to create original document using an application.
3.
Open printer driver settings screen
3.
4.
Select Paper Size
4.
Select registered user-defined paper 1 from
Custom Paper Size
in
Page Setup
tab's
Page Size
.
5.
Complete the setup
5.
Click
OK
.
When you print, the hanging or horizontal banner is printed by using the user-defined size.
Note
• Maximum printable length is 18.0m. In the event the enlarged length exceeds 18.0m, the part of the
image exceeding the length will not be printed.
• If printing cannot be performed correctly, you may be able to improve printing by using the
Special
Settings
dialog box on the
Layout
tab to change
FineZoom Settings
to
Yes
.
548