Canon imagePROGRAF GP-4000 - Manual (Page 429)

Firmware update
Important
• When you use this function, make sure the printer is connected to the Internet.
• The administrator password is required to change settings if it is enabled for changing settings using the
operation panel.
Using Operation Panel
1. Tap Printer settings on HOME screen. 1.
Home Screen Menu Composition
2. Tap Firmware update . 2.
Enter the password if it is enabled.
3. Tap Install update . 3.
4. Tap Yes . 4.
5. Confirm displayed message and tap Start update . 5.
Using Remote UI
1. Start up Remote UI. 1.
Start up Remote UI
2. Select Firmware update . 2.
3. Select Install update . 3.
4. Confirm displayed message and select Update . 4.
Note
• If the firmware update is not complete, check the following and take an appropriate action. •
Check the network settings such as a wireless router.
If Cannot connect to the server. is displayed on the touch screen, select OK and try again
after a while.
429