Canon imagePROGRAF GP-4000 - Manual (Page 647)

Device Settings Tab Description
Many of the tabs in the Properties windows of the printer are controlled by Windows. However, the Device
Settings tab is for specifying printer configuration-related settings and is part of the printer driver.
The Device Settings tab allows you to specify settings related to the printer unit.
Automatically switch paper sources (paper size priority)
Prints after automatically switching between roll paper 1 and roll paper 2 depending on the size of the
paper to be printed.
This will save paper as the roll paper that will give the smallest margin when printing is automatically
selected.
Important
• Make sure that the same type of paper is used in the upper level and lower level of the printer.
Printing is not possible when different types of paper are used.
• Be sure to click Get Information... from the Device Settings tab to get information on the roll
paper width. You may not be able to print correctly if the roll paper width is not correctly set.
• Be sure to select Roll Paper (Auto) as Paper Source from Page Setup . This function cannot be
used unless Roll Paper (Auto) is selected.
Roll Paper Width 1
Sets the width of the roll paper loaded in the upper level (Roll 1).
Roll Paper Width 2
Sets the width of the roll paper loaded in the lower level (Roll 2).
Get Information...
Acquire information on the attachment of the roll unit or roll paper 1 or roll paper 2 paper width from
the printer.
Based on this information, the
Roll Unit and Automatically switch paper sources (paper size
priority) , and roll width settings are automatically switched.
647