Canon imagePROGRAF GP-4000 - Manual (Page 91)

Loading the Upper Roll on the Printer
Follow these steps to load rolls in the printer.
When selecting Enable in Roll paper auto feed , the roll paper is fed automatically by simply loading it.
Important
• Always load rolls when the printer is on. If the printer is off when you load a roll, the paper may not be •
advanced correctly when you turn the printer on.
• Before loading a roll, confirm whether the inside of the top cover or the output guide is soiled. If these •
areas are dirty, we recommend cleaning them in advance. (See " Cleaning Inside the Top Cover .").
• If Paper retention settings is set to Release , the roll paper is not fed automatically. •
• For details on the paper that can feed roll paper automatically, see "Paper Information List." •
Note
• When using the roll unit, you can also load roll paper on the roll unit separately from the printer that is •
described here. (See " Loading the Lower Roll on the Roll Unit (Option) .")
• When roll paper cannot be fed automatically, see " Roll Paper Is not Switched Automatically ." •
1. Tap paper settings display area on Home screen of touch screen. 1.
Note
• If the Home screen does not appear, tap the HOME button. •
• When selecting Enable in Roll paper auto feed. •
Go to step 2.
• When selecting Disable in Roll paper auto feed. •
1. Tap area. 1.
2. Tap Load paper or Replace paper , check message that appears, and then tap Yes . 2.
Note
• If any cut sheet has been fed, or roll paper that will not be used has been fed from Roll 1 (Upper), •
a message is shown requesting you to remove it.
91