Custom size settings, Dialog box, Custom size settings dialog box (paper size) – Canon imagePROGRAF GP-4000 User Manual
Page 633
Paper Source
Shows the source from which paper is supplied.
You may be able to switch the paper source with the printer driver.
Roll Paper (Auto)
Depending on the paper settings on the printer driver and the paper information registered to the
printer, the printer automatically determines which roll paper to use and then feeds that paper.
Roll 1
Feeds paper from Roll 1.
Roll 2
Feeds paper from Roll 2.
Cut Sheet
Feeds paper using the cut paper.
Important
• Depending on the media type and size, the
Paper Source
settings that can be selected may differ.
Roll Paper Width
Select the roll paper width.
Select the width that matches the width of the roll paper loaded in the printer.
If you select
Custom Size (XXXX)
, the paper size set in the printer will be used.
The paper information set in the printer can be confirmed in
Get Information...
in the
Main
sheet.
If you select
User-defined1 (XXXX)
or
User-defined2 (XXXX)
, the
box is
displayed, where you can specify the paper length and width.
Roll Paper Options...
.
You can specify auto cut, banner printing, and other settings for printing on roll paper.
Output Method...
You can select
Output Method
and specify save settings for saving documents to a box.
Size Options...
.
The
Paper Size Options
dialog box allows you to create and register any user-defined paper.
Custom Size Settings dialog box (Paper Size)
This dialog box allows you to specify the size (width and height) of the custom paper.
Paper Size
Specifies the
Width
and the
Height
of the custom paper. Measurement is shown according to the
units specified in
Units
.
Units
Select the unit for entering a user-defined paper size.
633