Gasboy CFN Series Site Controller III Start-up - Manual (Page 99)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 93
Cash Drawer, Shifts Start-up Commands
4 Type E CO;I to enable the console ( Figure 13-34 ).
Figure 13-34: Example of E CO;I Command
P* E CO;I
P*
Cash Drawer, Shifts
To load the cash drawer and shifts information, proceed as follows:
1 Type RE TO;A ( Figure 13-35 ).
This resets the daily and cumulative totals to zero and automatically loads shift one.
If using the Shift Change package, use NEXTDAY command.
Figure 13-35: Example of RE TO;A Command with Prompt
P* RE TO;A
Verify (Y/N)? Y
P*
2 If the site has a cash drawer, type LO DR to enter the initial amount of cash in the drawer
(
Figure 13-36 ).
If using the Shift Change package, use LDDRAWER command.
Figure 13-36: Example of LO DR Command with Prompts
P* LO DR
Drawer number? 1
$ Amount? 150.00
P*
3 If you wish to load a shift other than shift one, type LO SH to load the current shift
( Figure 13-37 ).
Type the shift number at the prompt.
If using the Shift Change package, use NEXTDAY command to load the first shift.
Figure 13-37: Example of LO SH Command with Prompt
P* LO SH
Shift number? 1
P*