Gasboy CFN Series Site Controller III Start-up - Manual (Page 21)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 15
Load Fuel Inventory Site Information
Load Fuel Inventory
Note: Refer to MDE-4762 Site Controller III Manager’s Manual for Windows XP Embedded,
LO IN command.
Use the following table to load the initial inventory amounts and the reorder levels for your
fuel products. Once you have loaded the initial inventory amounts, you will use ADd
INventory to add to the inventory amount for the product. You will also use this command
later when you load inventory for your merchandise products, but you need to define these
products first.
Note: Normally fuel is tracked using the LOad TAnk command (refer to “Load Tank” below);
however, this command can also be used.
Product Number Quantity Reorder Level
Load Tank
Note: Refer to MDE-4762 Site Controller III Manager’s Manual for Windows XP Embedded,
LO TA command.
Use the following table to enter the initial tank inventory, product code and the reorder level
for each tank. Also refer to
“Load Fuel Inventory” above.
Tank Number Quantity Product Code Reorder Level