Gasboy CFN Series Site Controller III Start-up - Manual (Page 40)

Physical System Layout ICR Assembly
Page 34 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
ICR Assembly
1 Verify if the ICR is installed to allow adequate clearance for system maintenance. For systems
with receipt printers or pedestal pump controls, a minimum of 18 inches is required between
the post and any of the pumps or dispensers. This clearance meets the NFPA 30A and NFPA
70 requirements.
2 Remove the two tamper-proof screws from either side of the black bezel, located on the front
of the ICR head assembly. Unlock and lower the black bezel door.
3 Remove the six screws from the lower back side pedestal cover and remove the cover.
Note: No AC power should be present at TB6 in the ICR head assembly.
4 Verify if the conduit and all system, pump, and dispenser wiring is installed according to the
specifications detailed in the SC III Installation Manual. Noncompliance with these
specifications and the checks in the accompanying Start-up Form could void the warranty.
PCU(s)
1 Verify if the PCU(s) are installed in an area protected from direct contact with the weather
according to the SC III Installation Manual.
2 Verify if the conduit and all system, pump, and dispenser wiring is installed according to the
specifications detailed in the SC III Installation Manual. Noncompliance with these
specifications and the checks in the accompanying Start-up Form could void the warranty.
7. CONDUIT
All Metal Conduit: Indicate if all conduit is metal and not PVC. Circle Y for yes (all metal) or N for
no (not all metal conduit).
AC and DC is Separate
Conduit: Indicate if all wiring is separated in the appropriate conduits according to the
conduit specifications and exceptions detailed in the SC III Installation Manual.
Circle Y for yes if all AC and DC wiring is in separate conduits. Circle N for no
if AC and DC wiring is combined in conduits where it should not be.
Wiring Neatness: Indicate the overall neatness of the installer’s wiring. Is the appearance of the
wiring neat and orderly or is it very disorderly? Circle Good, Fair, or Bad.
Is shielded cable
used? Indicate if Gasboy C09655 or equivalent cable was used for communications
wiring. Circle Y for yes or N for no.