Gasboy CFN Series Site Controller III Start-up - Manual (Page 23)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 17
Load Pumps Site Information
Load Pumps
Note: Refer to MDE-4762 Site Controller III Manager’s Manual for Windows XP Embedded,
LO PU command.
Fill in the pump number, hose number (1 to 5 for each pump), the reading from the quantity
totalizer, and the reading from the dollar totalizer, if applicable.
Note: Quantity and $Amount are optional. Leave as 0 (zero) if desired. If you need more
space, photocopy this table.
Pump Hose Quantity $Amount Pump Hose Quantity $Amount
Load Cutoff
Note: Refer to MDE-4762 Site Controller III Manager’s Manual for Windows XP Embedded,
LO CU command.
Use the following table to note the amount the SC will authorize or request authorization for
when a customer requests a FILL. When you encode a limitation code on privately-issued
cards, that code overrides the pump fill limit. Also indicate on this table, the slow cutoff point,
at which the pump will slow prior to reaching the fill limit.
Pump Number Fill Limit Slow Cutoff