Gasboy CFN Series Site Controller III Start-up - Manual (Page 95)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 89
Card Authorizations, Limitations Start-up Commands
Card Authorizations, Limitations
Load Authorization
Type LO A;IC to load the fuel codes allowed for each authorization number ( Figure 13-23 ).
For initial start-up, assign fuel codes to all authorization codes, beginning with code 1 and
continuing through code 99. While up to 99 codes are possible, most systems use much less;
the default is 20.
Refer to MDE-4762 Site Controller III Manager’s Manual for Windows XP Embedded for an
explanation of authorization for non-fuel products.
Figure 13-23: Example of LO A;IC Command with Prompts
P* LO A;IC
Auth # ? 1
Product code? 1
Product code? 2
Product code?
Auth # ? 2
Product code? 3
Product code?
Auth # ?
P*
Load Limitation
Type LO LI;IC to assign the maximum fuel quantities to be used in limitation codes
( Figure 13-24 ).
For initial start-up, assign quantities to all codes, beginning with code 0 and continuing
through code 99. While up to 99 codes are possible, most systems use much less. The default
is 20.
Note: If the number in LIMIT? is preceded by a dollar sign, the value is in dollars ($20 in the
first example). If the LIMIT? is typed alone, the value is assumed to be gallons (25
gallons in the second example).
Figure 13-24: Example of LO LI;IC Command with Prompts
P* LO LI;IC
Limitation code? 1
Limit? $20
Limitation code? 2
Limit? 25
Limitation code?
P*