Gasboy CFN Series Site Controller III Start-up - Manual (Page 84)

Pump/Dispenser Automatic Test Master/Satellite Dispensers with Fuel Point
Page 78 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
Master/Satellite Dispensers with Fuel Point
The design of the Fuel Point system allows a nozzle ring on the master dispenser only. That
means the master nozzle must always be inserted in the truck’s fill pipe with the tank ring in
order for the satellite dispenser to operate. If the truck must be able to pull into the fuel lane
from either direction, then you may add a tank ring to both fill pipes.
Using the Chain Pump Feature with Fuel Point
The chain pump feature is used when activation of a fuel dispenser also turns on a bank of
fluid reels. In this application, the dispenser is known as the master of the chain. Only the
master of the chain has a nozzle ring, so its hose must remain in the fill pipe until all fueling
and fluid hoses are finished pumping.
Fuel Point - Gate Activation Test
This test should not be run until at least one successful fueling transaction is performed, as in
the tests above.
To perform the Fuel Point - Gate Activation Test, proceed as follows:
1 Position the vehicle over the ground loop antenna.
Within a few seconds, the gate opener should operate.
2 Follow the gate opener manufacturer’s operating instructions.
3 Verify if the system records the correct VM data.