Gasboy CFN Series Site Controller III Start-up - Manual (Page 38)

Begin Start-up Form Parts 1 through 6
Page 32 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
5. BREAKER NUMBERS
Indicate the breaker number for each of the following. All breakers pertaining to the system should be in
the OFF position.
Power conditioner:
AC Surge Protector:
(Profit Point)
Islander:
(N/A for SC III)
PCUs:
(PCUs)
ICRs:
Hose/Brkr #:
(hose outlets 1 to 32)
Answer the following questions:
What components are on power conditioner? Fill in all that apply.
What components are on AC Surge Protector? Fill in all that apply.
Are all Gasboy components on same breaker? Answer Y or N.
Notes:
1. The AC Surge Protector Strip must be on its own separate breaker. The SC, printer, and monitor must
be plugged into the same AC Surge Protector Strip. The Profit Point must also be plugged into an AC
Surge Protector Strip.
2. The optional power conditioner should be on the same breaker as the AC Surge Protector; however, if
this is not possible, it must be in the same phase of power as the AC Surge Protector breaker. The SC
III, modem, standalone receipt printer, and console should be connected to the output of the power
conditioner, if used.
6. SYSTEM ENVIRONMENT
Describe the location and environment of each system component (for example, office, outside, air
conditioned, heated). Ensure that the SC III is well ventilated. Nothing should rest on the top of the SC
or around its vents.