Gasboy CFN Series Site Controller III Start-up - Manual (Page 115)

Sample Form
MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 109
Gasboy Motor Fuel Management System
Sample Form
Sample Form
5. BREAKER NUMBERS
Hose Brkr # Hose Brkr # Hose Brkr # Hose Brkr #
Power conditioner: N/A 1. 2 9. 17. 25.
AC Surge Protector: 1 2. 2 10. 18. 26.
Islander: N/A 3. 3 11. 19. 27.
PCU(s): 1 4. 3 12. 20. 28.
ICR(s): 1 5. 13. 21. 29.
FPR(s): 6. 14. 22. 30.
7. 15. 23. 31.
What components are on power conditioner? 8. 16. 24. 32.
N/A
What components are on AC surge protector?
SCIII, logger, modem, monitor Are all Gasboy components on same breaker? Y/N
6. SYSTEM ENVIRONMENT
Site Controller/Islander: inside office, air-conditioned
Console: inside office, air-conditioned
PCU(s): back room off of office
ICR(s): on island
Profit Point(s): N/A
FPRs: N/A
7. CONDUIT
All Metal Conduit? Y/N AC and DC in Separate Conduit? Y/N Wiring Neatness: Good/Fair/Bad
Is shielded cable (as specified in the Installation Manual) used? Y/N
If you answered NO to the above questions, contact Gasboy before proceeding.
8. SYSTEM POWER
Power Conditioner: Hot to Neutral N/A VAC Hot to Ground N/A VAC Neutral to Ground N/A VAC
AC Surge Protector: Hot to Neutral 120 VAC Hot to Ground 120 VAC Neutral to Ground 0 VAC
Islander: Hot to Neutral N/A VAC Hot to Ground N/A VAC Neutral to Ground N/A VAC
PCU(s): Hot to Neutral 120 VAC Hot to Ground 120 VAC Neutral to Ground 0 VAC
ICR(s): Hot to Neutral 120 VAC Hot to Ground 120 VAC Neutral to Ground 0 VAC
FPR(s): Hot to Neutral N/A VAC Hot to Ground - VAC Neutral to Ground - VAC
Grounding method: neutral and ground bus bars bonded to single ground rod