Gasboy CFN Series Site Controller III Start-up - Manual (Page 34)

Site Information Worksheet for Pump/CRIND Device - PC Interface (if used)
Page 28 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
Worksheet for Pump/CRIND Device - PC Interface (if used)
Pump
Number
(Note 1)
Pump Type (Note 2)
(H111, MPD-3, and so on) 2-wire Address
(Notes 1 & 3) Number of
Hoses
Card Reader IN Dispenser
(CRIND) Address/Reader
Address
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
10 10
11 11
12 12
13 13
14 14
15 15
16 16
17 1
18 2
19 3
20 4
21 5
22 6
23 7
24 8
25 9
26 10
27 11
28 12
29 13
30 14
31 15
32 16
Notes:
1. Pumps 17 - 32 require a second gilpump.exe session on a separate serial port. In the parameter file for that
session, set
FIRST_CHANNEL_LAST_ADDRESS = 16. Set up the gilpump.exe and crind.exe sessions using the release
diskette for each. Refer to the appropriate installation manual for each for more information.
2. Pump Type is determined automatically. This column is optional.
3. The Pump Number and the 2-wire Address are the same unless the FIRST_CHANNEL_LAST_ADDRESS
parameter is set. In this case, the 2-wire Address is the Pump Number minus the
FIRST_CHANNEL_LAST_ADDRESS setting.