Gasboy CFN Series Site Controller III Start-up - Manual (Page 24)

Site Information Load Tax
Page 18 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
Load Tax
Note: Refer to MDE-4762 Site Controller III Manager’s Manual for Windows XP Embedded,
LO TAX command.
Use the following table to enter the names of the tax accumulators. Tax accumulators keep a
running total of taxes collected in up to eight categories. Tax formulas are specified in system
configuration or by using the TAX command.
Tax # Name (up to 7 characters)
Lockout Type
Note: Refer to MDE-4762 Site Controller III Manager’s Manual for Windows XP Embedded,
LOC CA or UN CA command.
Indicate type of lockout: Positive Negative
Authorization and Limitation Codes
Note: Refer to MDE-4602 CFN Card Encoding Manual, MDE-4762 Site Controller III
Manager’s Manual for Windows XP Embedded, LO A, LO LI commands.
If the customer is using private-issue cards, you may also need to load authorization codes and
limitation codes for the cards. Values for these codes should have been assigned when the
cards were encoded. Special templates for defining these codes appear in the Card Encoding
Manual.