Gasboy CFN Series Site Controller III Start-up - Manual (Page 17)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 11
Communication Port Settings Site Information
3 – Site Information
Site information must be loaded before the SC III system becomes operational. This section
provides a template for you to fill in the information needed to perform the start-up commands
(refer to
“Start-up Commands” on page 79 ). Do not perform the commands at this time.
Confirm with the customer and fill in the information that he or she will be using (for example,
fuel authorizations, limitations, and so on). Successful start-up requires coordination between
separate components of the system: installation, card encoding, and operation. Each item
contains a manual reference where you can find additional information. For private-issue
cards, the system identification, fuel authorization, fuel limitation codes, and price levels are
encoded on the access cards and then entered into the system via commands. The commands
you enter must match what is encoded on the cards. MDE-4602 CFN Series Card Encoding
Manual explains the encoding of these items.
Note: The tables in this section are meant to be reused. Make a photocopy of this section
before filling in table data.
Communication Port Settings
Note: Refer to MDE-4773 CFN III Configuration Manual for Windows XP Embedded.
Indicate the device connected to each of the ports you will use and the baud rates, if known.
The baud rate must match the baud rate of the device that is being connected to the port. Port
configuration assignments and baud rates are done through the site configuration. Port wiring
is no longer set by jumpers. You must use the correct cable for the devices connected. Refer to
MDE-4298 CFN Series Site Controller III Installation Manual for cabling requirements.
Port Device Baud Rate
1
4
5
6
COM1
COM2
COM3
COM4
COM5
COM6
LPT1 Printer (Y/N) N/A