Gasboy CFN Series Site Controller III Start-up - Manual (Page 98)

Start-up Commands Enable Devices
Page 92 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
4 Use the E PRO command to set product attributes ( Figure 13-30 ). Refer to MDE-4762 Site
Controller III Manager’s Manual for Windows XP Embedded or the Pocket Reference for a
list of product attributes.
Note: The LOad Fuel command automatically sets attribute 8 for that product. If you do not
want it to be attribute 8, you must disable it. Refer to MDE-4762 Site Controller III
Manager’s Manual for Windows XP Embedded, EN PRO command.
Figure 13-30: Example of E PRO Command with Prompts
P* E PRO
Product code? 11
Type? 4
P*
Enable Devices
To enable the devices, proceed as follows:
1 Type E PC;I to enable the PCU ( Figure 13-31 ).
Figure 13-31: Example of E PC;I Command
P* E PC;I
P*
2 Type E PU;I to enable all the pumps ( Figure 13-32 ).
Figure 13-32: Example of E PU;I Command
P* E PU;I
P*
3 Type E RE;I to enable the readers ( Figure 13-33 ).
Figure 13-33: Example of E RE;I Command
P* E RE;I
P*