Gasboy CFN Series Site Controller III Start-up - Manual (Page 90)

Start-up Commands Receipt Header, Broadcast Messages
Page 84 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
Receipt Header, Broadcast Messages
To create receipt headers and broadcast messages, proceed as follows:
1 Type LO H;IC to load into the system the receipt heading and footing messages for the receipt
printer(s) (
Figure 13-9 ).
(For systems with optional receipt printer only).
If using Tokheim DPTs, contact GASBOY Technical Service for information.
Figure 13-9: Example of LO H;IC Command with Prompts
P* LO H;IC
Line number (0, 0X, 1X) ? 1
Heading line? CFN AUTOMATED SYSTEM
Line number (0, 0X, 1X) ? 2
Heading line? 24 HR. FUELING
Line number (0, 0X, 1X) ? 11
Footing line? THANK YOU
Line number (0, 0X, 1X) ? 12
Footing line? PLEASE COME AGAIN
Line number (0, 0X, 1X) ? 0
Form feed length? 5
Line number (0, 0X, 1X) ?
P*
2 Type LO ME;IC to load into the system the broadcast messages for the reader terminal
( Figure 13-10 ).
Starting with message 1, type the message number, the time in seconds to be displayed, and
the text of the message (up to 20 characters). Continue for up to 10 lines (messages).
Note: If Tokheim DPTs are being used, contact GASBOY Technical Service for assistance.
Figure 13-10: Example of LO ME;IC Command with Prompts
P* LO ME;IC
Message number? 1
Display time is seconds? 2
Message to display? WELCOME PATRONS
Message number?
P*