Gasboy CFN Series Site Controller III Start-up - Manual (Page 85)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 79
Start-up Commands
13 – Start-up Commands
Some of the commands in this section use the; I option. This command option
should be used only at start-up. It initializes (erases) any data previously entered
for these commands. Subsequent use of these commands should omit the; I
option.
CAUTION
Use the following commands to set up the system at the initial start-up. Depending on the
particular configuration, some of these commands need not be performed. All commands are
covered in more detail in MDE-4762 Site Controller III Manager’s Manual for Windows XP
Embedded.
If you filled in the checklist in Section 2 of this manual, you already have the information you
need to start up the system. In all examples, bold represents the information that you enter, and
represents the RETURN key.
To show that it is ready to accept input, the SC displays a letter asterisk combination (P*). The
examples in this section all use the P* prompt.