Gasboy CFN Series Site Controller III Start-up - Manual (Page 66)

Component Power-up and Configuration Okidata® Printer/Logger
Page 60 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
Printer Configuration Submenu
The printer configuration submenu allows you to select a forms or invoice printer and specify
the port (LPT1 or LPT2) to which it is connected. The receipt printer, if present, is still
connected to LPT1 and prints receipts regardless of this configuration. Refer to MDE-4356
Profit Point Reference Manual for details.
Scanner Configuration
When purchased from Gasboy, the scanner should be set up at the factory. If it is not, it is
programmed by scanning bar codes supplied with the scanner. A configuration instruction
sheet, including a list of required bar codes, is packed with the scanner. Refer to MDE-4356
Profit Point Reference Manual for scanner port parameters.
Okidata ® Printer/Logger
The following printer switch settings are applicable for the Okidata 184 printer when
connected to a GASBOY CFN Fuel Management System. This document is not intended to be
a complete reference for the printer. Consult the documentation that came with the printer.
To prepare the Okidata 184 printer for operation with your GASBOY Fuel Management
System, perform the following steps. Install and complete the setup of the printer as specified
in the manufacturer's setup instructions. Then set up the switches as follows:
SW1-1 ON Parity: Odd
SW1-2 ON Parity: Without
SW1-3 ON Data bits: 8
SW1-4 OFF Protocol: XON/XOFF
SW1-5 ON Test select: Circuit
SW1-6 ON Mode select: Print
SW1-7 ON Busy line selection: DTR - Pin 20
SW1-8 ON Busy line selection: DTR - Pin 20
SW2
Baud Rate SW2-1 SW2-2 SW3-3
9600 OFF ON ON
2400 OFF OFF ON
1200 ON ON OFF
300 ON OFF OFF
Note: Any change to the baud rate must also be changed on the Link Terminal
Communications Setup screen, Aux Baud parameter.