Gasboy CFN Series Site Controller III Start-up User Manual
Page 36
Begin Start-up Form
Parts 1 through 6
Page 30 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
2. SYSTEM IDENTIFICATION
Site #:
Number of the site.
Checkmark the components that this site has.
Indicate the serial number, program version number for each of the following:
SC III:
SC III unit. Also indicate the program name and debug version.
PCU (s):
Serial number of PCU; program version from PCU Central Processing Unit (CPU)
Printed Circuit Board (PCB).
If pedestal PCU, program version from PCU CPU PCB.
ICR (s):
ICRs, program version from Reader CPU PCB.
Also indicate Y or N if the ICR has a receipt printer, has pedestal PCU, or is set up
as a car wash or gate controller.
Console:
Profit Point:
gilpump PC Driver:
(current loop replacement)
CRIND PC Driver:
(current loop replacement)
Standalone Receipt
Printer:
PIN Pad:
Complete the following section only for Gasboy PC packages.
PC SOFTWARE:
if applicable, indicate the version number of the PC software assigned to this site.
PC Make and Model:
Indicate the make and model of the PC being used at this site.
DOS Version:
Indicate the DOS version that is running on the customer’s PC.
Note: The serial number for each system device can be found on the ID tag located on the outside cover of that
device.
3. SYSTEM DESCRIPTION
PUMP #:
Indicates the pump number.
HOSE #:
Indicates hose outlet number.
FUEL TYPE:
The type of fuel dispensed by that pump or dispenser (for example, No-Lead,
Regular, and so on).
FUEL CODE:
The product code number (1 or 2 digits) assigned to that fuel type.
PUMP MAKE:
The name of the manufacturer of the pump or dispenser.
MODEL #:
The model number of the pump or dispenser.
SERIAL #:
The serial number of the pump or dispenser.
RESET:
The type of reset used in the pump (Veeder-Root, Tokheim #77, and so on)
TYPE SUC/SUB:
The type of pump used to dispense the fuel. Submersible pump (SUB) located
in the tank or is it a suction pump (SUC) located in the pump housing? Circle
one.
PULSER RATE:
The pulser rate of the pulser used by that pump or dispenser (for example,
10:1, 100:1)
STARTER RELAY:
Is an external starter relay used to supply power to the pump? Circle Y for yes
or N for no.