Gasboy CFN Series Site Controller III Start-up - Manual (Page 57)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 51
Pumps and Dispensers Jumpers and Switch Settings
FPR Address Switch 3 Switch 4
1 OFF OFF
2 OFF ON
3 ON OFF
4 ON ON
Pumps and Dispensers
If you are using GASBOY Series 9800 pumps and dispensers, there are switches that must be
set correctly to insure proper operation of your CFN system. Refer to Series 9800 Installation/
Operation Manual for details.
If you are using a Gilbarco CRIND device or another pump interface (Tokheim DPTs,
Wayne
® , and so on) refer to C09146 Pumps Interface Manual.
Standalone Star Printer
The switches on the standalone Star printer are set at the factory and should be correct. If
change is needed, refer to C01759 CFN Diagnostic Manual for details.