Gasboy CFN Series Site Controller III Start-up - Manual (Page 83)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 77
Reader Entries and Fuel Point Pump/Dispenser Automatic Test
5 After a few gallons, hang the nozzle back on the pump; verify if the correct EID and VM data
have been recorded.
6 Repeat for all hose outlets.
Reader Entries and Fuel Point
If your system was ordered with the reader entry option, you must enter data at the card reader
with every Fuel Point transaction. This entered data is combined with the data already
programmed into the VM.
1 Insert the wired-hose into the vehicle's fill pipe, or, park the vehicle over the ground loop,
whichever is applicable.
2 Go to the card reader that is assigned to the Fuel Point controlling this hose.
The reader will be scrolling broadcast messages, or a SLIDE CARD message.
(The card reader is assigned to a FPR in the FUELPT.BIN configuration program).
3 On the keypad, press the pump number that you are using, followed by ENTER.
The display now prompts you to enter certain data. Follow the prompts until finished.
4 The pump should turn on when all entries have been successfully entered.
Obtaining a Receipt for Fuel Point Transactions
If Using an ICR
To obtain a receipt for Fuel Point transactions when using an ICR, proceed as follows:
1 Once the transaction has been completed, go to the ICR.
The reader will be scrolling broadcast messages, or a SLIDE CARD message.
2 Select the pump number you just used, followed by ENTER.
There is no further prompting for the receipt. The receipt will print for the last transaction that
occurred at that pump within the last 20 minutes. Since only the last transaction at that pump is
available as a receipt, you must get your receipt before allowing another transaction to
complete at that pump.
If Using an Electronic Dispenser with a Built-in Printer
After the transaction has completed, the receipt will be printed automatically, or the display
may prompt for the receipt, depending on the configuration in SYS_PAR.BIN.