Gasboy CFN Series Site Controller III Start-up - Manual (Page 109)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 103
Customer Training
Demonstrate how to clean the disk drive using the GASBOY disk cleaning kit (C01770)
GASBOY recommends that you clean your disk drive at least once a week, although
more frequent cleaning may be necessary in high dirt or dust areas.
1. Remove the contents of the disk cleaning kit from the box.
The drive cleaning kit, if used as directed, will last one year.
Once the pressure arm has been removed, do not use this cleaning kit for a
single-sided drive.
CAUTION
2. Since the disk drive on the SC III is a dual-sided drive, remove the pressure arm on the
cleaning diskette by bending it back until it snaps off.
3. Open the bottle of cleaning fluid and fully saturate the area exposed in each of the two
large cutouts.
4. Insert the cleaning diskette into the drive with the number of uses label facing up.
5. At the PC, type DIR A: and press ENTER.
6. Sign on to the SC III and type SYS and press ENTER.
You will hear the drive activate.
Wait 20 to 30 seconds.
It may be necessary to run the DIR A: command again.
7. After 20 to 30 seconds, type exit and press RETURN.
This deactivates the drive and completes the cleaning process.
8. After the disk drive access light goes off, remove the diskette and check off a box on
the usage label.
After the recommended number of uses, or if the diskette becomes discolored, discard the
diskette.
For systems with Fuel Point, demonstrate the following:
Using the Programmer to program, read, and calibrate a VM
Using the Master Authorizer to authorize a sale
Using the VM to authorize a sale
How to suspend and resume Fuel Point transactions