Gasboy CFN Series Site Controller III Start-up - Manual (Page 101)

MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008 Page 95
Reset Transaction File Start-up Commands
Reset Transaction File
The following command sequence enables you to reset and initialize the transaction file
(
Figure 13-41 ).
The command sequence is explained in “Explanation of Commands” .
This command procedure should only be done at start-up.
CAUTION
Figure 13-41: Example of Reset Transaction File Command Sequence
P* FIX TR;I
Verify (y/n)? y
P* RE TR;A
Verify (y/n)? y
P* RE TR;I
Verify (y/n)? y
P* RE TR 0
P* RE TR 1
Verify (y/n)? y
P*
Explanation of Commands
FIX TR;I Resets the transaction file and sets all transaction numbers to -1. Use this
command only at start-up as it is irreversible; all stored transactions will be
made unreadable. Answer yes, y, to the VERIFY prompt and press RETURN.
RE TR;A Resets all transaction file pointers.
RE TR:I Clears any temporary or transaction in progress files.
LO TR 0 Loads a new transaction number of 0 (zero).
RE TR 1 Resets the transaction pointer to begin at transaction 1.