Gasboy CFN Series Site Controller III Start-up - Manual (Page 80)

Pump/Dispenser Automatic Test Profit Point or SC III/POS WS - Postpay Pump Activation Test (Optional)
Page 74 MDE-4793A CFN Series Site Controller III Start-up Manual for CFN III Versions 3.5 and above · November 2008
5 Turn on all other hose handles.
Only Hose 1 should be activated or dispense product.
6 Turn off all other hose handles.
7 Turn off the handle for Hose 1.
8 Place the handle for Hose 1 back into the ON position.
Hose 1 should not reset and should not dispense product.
9 Verify if the quantity displayed on the Hose 1 register matches the quantity (and price, if
applicable) recorded on the system printout.
10 Repeat steps 2 through 9 above for all hose outlets.
Note: Continue with steps 11 through 15 below only if you are using dispensers or dual hose
single motor SUCs.
11 Using the test card, select two hose outlets of the same product type (that use the same SUB).
12 Turn on both pump handles.
Both hose outlets should reset and be able to dispense product.
13 While dispensing product from one hose (A), allow the other hose (B) to time out.
14 When Hose B has timed out, try to dispense product from it by squeezing the nozzle.
You should not be able to dispense product from Hose B. If you can, verify if the dispensers
use solenoid valves rather than hydraulic valves, and re-check that particular pump’s or
dispenser’s wiring.
15 Repeat steps 11 through 14 above for all combinations of hose outlets of the same product
type.
Profit Point or SC III/POS WS - Postpay Pump Activation
Test (Optional)
For more information, refer to Profit Point Clerk’s Manual.
To perform the Profit Point or SC III/POS WS - Postpay Pump Activation Test, proceed as
follows:
1 Turn the pump handle of pump 1.
Profit Point beeps three times at set intervals, indicating pump is offhook.
2 On the Profit Point, press OFF HOOK button, then START.
3 Dispense some product from pump 1; then turn pump off using pump handle.