Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 79)

Chapter 2 - VMS Installation 2-39
MN/22156, rev 12 ViperGlobe Installation
Verify ViperGlobe Installation
After installation, and with all Client connections established to the VMS
server, launch ViperGlobe:
1. Open ViperGlobe by selecting Vipersat Network Globe from the path Start
> Programs > VMS > Vipersat Network Globe .
2. At the connection prompt, enter the IP address of the Active VMS server and
click on the OK button in the Connect To dialog.
3. The ViperGlobe window will appear, as shown in figure 2-46.
Note that this Globe View example shows an existing Vipersat network that
has already been configured.
Figure 2-46 ViperGlobe window
This completes the ViperGlobe installation procedure.