Full duplex circuit configuration, Full duplex circuit configuration -15, Figure 7-10 create oob circuit, hub and remote – Comtech EF Data VMS v3.12.x Vipersat User Manual
Page 371: Commands
![background image](https://www.manualsdir.com/files/778979/content/doc371.png)
Chapter
7 -
Out-of-Band Units
7-15
MN/22156, rev 12
Switching Out-of-Band Modems
Figure 7-10 Create OOB Circuit, Hub and Remote commands
Because circuits are associated with sites, the Create OOB Circuit command is
not available from the Group or Network level.
Full Duplex Circuit Configuration
Full duplex point-to-point circuits are defined by the unit (modem) and consist
of 2 channels (mod to demod connections). Defining the circuit by unit ensures
that it consists of 2 modems, rather than independent modulators and demodula-
tors, which is typically required for synchronous serial circuits. It also makes it
fairly simple to configure.
Note: Note that this type of circuit is only possible when using modem units that
support P2P functionality.
1.
Right-click on the Remote site icon that will be utilizing the circuit and
select Create OOB Circuit from the drop-down menu to open the Circuit
Creation Wizard. The Circuit Identification dialog will appear, as shown in
NOTE