Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 235)

Chapter 4 - Configuring Network Modems 4-17
MN/22156, rev 12 Network
For a Hub unit that is providing the DVB-S2 TDM outbound to the Remotes,
static routes must also be created for the following:
• The ECM TAP multicast address (M&C).
• The VMS multicast address (M&C).
• Route statements defining satellite communications with the Remote
units; one for traffic and one for management, per Remote. An option
for reducing the number of routes required is to enter a single route
using a supernet address that will handle satellite communications with
all of the remote subnets.
1. From the tree menu, select Routes to open the Routing Table dialog. All
current static routes are displayed in the table listing.
The static routing configuration for a typical Hub CDM-800 unit is shown
in figure 4-9 and figure 4-10.
Routing for a typical CDM-840 is shown in figure 4-11.
Figure 4-9 Hub Routing Table dialog, CDM-800