Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 375)

Chapter 7 - Out-of-Band Units 7-19
MN/22156, rev 12 Switching Out-of-Band Modems
This box must be checked if the circuit requires an exact match to the
requested bit rate in order to function correctly, such as with an E1 interface.
14. Click on the Next button (becomes active when configuration parameters
have been set) to proceed to the wizard Summary Page (figure 7-14).
Carefully review all information on this page prior to proceeding. The Back
button is available to retrace the configuration and make any changes that
might be necessary before final circuit creation.
Figure 7-14 Summary Page, Full Duplex P2P
15. Click on the Next button to execute the creation of the circuit. The Commit
Page will be displayed.
If the configuration is accepted by the wizard, the page will indicate that the
Circuit Creation Succeeded, accompanied by a green check mark, as shown in
figure 7-15. Click on the Close button to exit the wizard.