Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 67)

Chapter 2 - VMS Installation 2-27
MN/22156, rev 12 VMS Server Installation
Verify Server Installation
This verification process utilizes the ViperView Client, and thus can only be
executed using just the server when a Full Install has been performed. For a
Server Install, verification of successful installation requires the use of a Client
workstation (see “Verify Client Installation” on page 2-33).
1. Insert the Vipersat Crypto-Key into an available USB port on the VMS
server. This key is required to run the Vipersat Management System Service
(VOS).
2. Open the Services window on the server by selecting Services from the Start
> Administrative Tools menu.
Figure 2-31 Services, Administrative Tools menu
3. Select Vipersat Management System from the Services list as shown in
figure 2-32, then click on Start the service.