Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 73)

Chapter 2 - VMS Installation 2-33
MN/22156, rev 12 VMS Client Installation
Figure 2-37 Client Installation Type
Once the installation wizard is finished, return here to continue with the follow-
ing section.
Create Client Accounts
It is necessary to configure the appropriate security settings for the Client work-
station to gain network access privileges to the VMS server.
Follow the procedure in Appendix G, “VMS Client Users” for setting up client
user accounts.
Verify Client Installation
After installation, verify that the VMS Client installation was successful by
running the program. The VMS Server must be running VOS, the Vipersat
Management System service (see “Verify Server Installation” on page 2-27 for
the necessary steps to start the VMS service).
1. Open the Connection Manager using the path Start > Programs > VMS >
Connection Manager .
2. At the connection prompt in the Connect dialog, enter the IP address of the
VMS Server and click on the OK button (figure 2-38).