Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 363)

Chapter 7 - Out-of-Band Units 7-7
MN/22156, rev 12 SNMP Modem Manager
Figure 7-4 CDM-600L Unit Properties dialog
Note that, in this dialog, the IP Address field is a read-only display for the
target modem. To change the address, the modem must be deleted from the
SNMP Modem Manager, then declared anew.
6. Click on Apply, then Close the window.
Once the modem and its companion CiM-25 are configured and are connected
to the network, the unit will appear in the correct subnet under the Subnet
Manager as well as under the SNMP Modem Manager, as shown in figure 7-5.
And, if the Network Manager has been configured to include the subnet, the
new modem unit will appear there also (figure 7-6).
Figure 7-5 SNMP Modem Manager units